The ES550 APC Back UPS ES battery replacement can be replaced with 1 Piece of 12 Volt, 7 Amp Hour battery, for the higher capacity battery which gives you a longer runtime select the upgrade option below and get the 9Ah battery. The full name for this UPS is the APC Back-UPS ES 550 battery backup, manufacturers part number is BE550G, 550VA / 330 Watt. This is one of the smaller back up unit's from APC and is designed to protect your equipment from power surges and spikes that can cause damage to your equipment. It will save open files and will gracefully close down the connected PC in the event of an extended power outage. This is quite a simple battery replacement and heres how:-
- Flip the unit onto it's backside
- remove the plastic back plate.
- Slide the battery out.
- Disconnect the red positve wire and the black negative wire.
- Remove the plastic protector from the positive terminal keep this to install on the replacement battery.
- Install the plastic clip onto the positive terminal of the new battery.
- Reconnect the black lead onto the negative black terminal of the new battery and then connect the Red lead to the positive of the new battery.
- Insert the battery back into the compartmment of the ES550 unit.
- Slide the compartment cover back onto the unit.
- There should be some charge in the batteries. Test the battery is connected by powering the unit up. The green power light should illuminate.
- Now plug the unit in the mains, The unit will take a few hours to fully charge after that.
- Job Done - Plug your devices back in and now you are protected again.
You will probably need to replace the ES550 battery around every three to four years sometimes longer. We do recommend however that you try a test on them by disconnecting the power every year and making sure that they power the devices they are connected to for the required amount of time.
MORE INFO:-
Please Note: This battery does not come with cables/adapters to connect to your specific device. Make sure that you order a battery with the correct size terminals. The battery is manufactured from an abs plastic casing.
- The 12V 7A/H battery is used in a variety of applications.
- The RBC2 battery uses AGM Technology.
- It is a Maintenance-Free Design and as such is totally spill proof.
- Please make sure that you check the dimensions of the battery for ES550 before ordering. Shipping is expensive and it's better to get it right first time.
RBC SPECIFICATIONS |
# In Pack | 1 Piece |
Chemistry | AGM |
Voltage | 12 |
Capacity (Ah) | 7 |
Connector | T2 |
Weight (Lbs) | 4.85 |
Weight (Kgs) | 2.2 |
Warranty | 1 Year |
RBC Model | RBC2 |
Spec-Sheet | CB127.5 Specs |
EACH BATTERY DIMENSIONS |
Length (inches | 5.95 |
Width (inches) | 2.56 |
HT (Inches) | 3.7 |
HT Top T (In) | 3.94 |
Length (mm) | 151 |
Width (mm) | 65 |
HT (mm) | 94 |
HT Top T (mm) | 100 |
Model it Fit's | ES550 |
Size Variance | + or - 1% |
If you have any further questions please do not hesitate to contact us. If you want a longer runtime on your ES550 please select the 12V 9Ah upgrade option which has approximately 23% more capacity.