Our battery grip should have the same exact dimensions and fitment as the original grip, the fit and finish is checked before dispatch. Finding the right battery grip for your product can be difficult. There are so many models and part numbers it can be really confusing. it's easier to reach out to us first than it is to return the product later. Please contact us if you are really not sure which battery grip you need. This battery grip is designed to replace the battery grips in models described below
Chemistry | Lithium Batteries or Alkaline Batteries |
Battery Grip # | BP-D700 |
Battery Model # | EN-EL3E |
Warranty | 1 Year |
Model Number | CS-MBD10 |
Color | Black |
Dimensions(mm) | 150.50 x 52.00 x 75.50mm |
Replaces Manufacturers | Nikon |
Finding the right battery grip for your product can be difficult. There are so many models and part numbers it can be really confusing. it's easier to reach out to us first than it is to return the product later. Please contact us if you are really not sure which battery grip you need. If both your battery grip and model number of your device is shown in the table below you should be good to order. Most of our products come with a one-year warranty unless otherwise stated. The one-year warranty that we offer covers any manufacturing defect. Please note that the warranty does not cover damages due to misuse of the battery nor diminishing run time due to normal wear and tear. The average life of a Li-ion battery is around 400 cycles, This is the same for Lithium Polymer. Nimh should last for around 500 cycles. (A cycle is a discharge and recharge.) Please remember that a cycle will still be used, even if only partially discharged then recharged. it's always best to run the battery low and recharge when the battery reaches about 10% of it's charge left. This will extend the life of the battery. Being an ISO 9001 certified factory means that the Cameron Sino range of batteries have to be manufactured with only the highest quality components. You can rest assured that the batteries we supply are fully tested in the devices they are designed for and are built with all the same safety protocols as the original OEM battery. This product is designed to replace batteries as shown in the specifications table below.
Special Remarks:-With shutter, use 1pcs EN-EL3e, EN-EL4, EN-EL4a, and 8pcs AA / LR6 / HR6 / FR6 batteries, can use car charger to charge EN-El3e without taking it out from the grip.- BATTERIES NOT INCLUDED
Device Models and Battery numbers that this battery is known to support:-
Device Models Supported |
Nikon, D300, D700, D900 |
Battery Models Supported |
Nikon, Bp-d700, Mb-d10 |
Manufacturers that this product will replace:-
Manufacturers Supported | Actual manufacturer |
Nikon | Cameron Sino |
Battery Selection (Please read - Important)
All information that we provide with regards to fitment is supplied by the manufacturers as a final check it's worth comparing your original battery with the one shown. We keep our records as up to date as possible but new fitments come on stream every week due to the launch of new products.